4.4 MP2000 Series Machine Controller Parameter Details
4.4.2 Motion Setting Parameter Details
4-43
Related parameters
• Setting parameters
SERVOPACK Parameter Setting
The actual torque limit is the lowest one of the values listed in a category in the following table.
For linear servomotors, the parameter numbers are different. Use Pn482 instead of Pn402 and Pn483 instead of
Pn403.
( 13 ) Secondly Speed Compensation
Register No. Name Setting Range Default Value Setting Unit Remarks
OL14
Positive Side Limiting
Torque/Thrust
Setting at the Speed Ref-
erence
–2
31
to 2
31
–1
30000
1 = 0.01%
or 0.0001%
To enable the setting, the
SERVOPACK parameter
also needs to be set.
Pn002 Setting
Forward Torque Limit Reverse Torque Limit
When OPTION.P_CL = 0 When OPTION.P_CL = 1 When OPTION.N_CL = 0 When OPTION.N_CL = 1
n.0
or
n.2
Pn402 setting
Pn402 setting,
Pn404 setting
Pn403 setting
Pn403 setting value,
Pn405 setting value,
n.1
Pn402 setting,
PTLIM (TLIM)
Pn402 setting,
Pn404 setting,
PTLIM (TLIM)
Pn403 setting,
NTLIM (TLIM)
Pn403 setting value,
Pn405 setting value,
NTLIM (TLIM)
n.3
Pn402 setting
Pn402 setting,
Pn404 setting,
PTLIM (TLIM)
Pn403 setting
Pn403 setting value,
Pn405 setting value,
NTLIM (TLIM)
Positive Side Limiting
Torque/Thrust Setting
at the Speed Reference
OL14
Torque limit input
Pn81F.1
= 2
The set value of PTLIM, NTLIM,
and TFF are ignored.
= 0
Pn002.0
= 3
= 1
PTLIM and NTLIM operate
as the torque limit values.
TFF operates as the torque feed
forward.
When P-CL and N-CL are available,
PTLIM and NTLIM operate
as the torque limit value.
OL16
Secondly Speed Compensation
Setting Range Setting Unit Default Value
−2
31
to 2
31
−1
Depends on the speed
unit set in Function Set-
ting 1 (setting parameter
OW03, bits 0 to 3).
0
Description
Set the speed feed forward amount for the Phase Reference (PHASE), Interpolation (INTERPOLATE), and Latch
(LATCH) commands.
The setting unit for Speed Compensation (setting parameter OW31) is 0.01% (fixed). The unit for this parameter,
however, can be selected using Speed Unit Selection.
When used at the same time as OW31, speed compensation can be performed twice.
The setting unit for this parameter depends on the Speed Unit Selection (OW03, bits 0 to 3), but
the result of applying the speed unit setting is not shown here.
(178 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji